Alpha One Trim Gauge Power No Change. With the drive on you need a long 1/4 drive extension with a u/j and 7/16 socket, with the drive hard to starboard you can undo the bolt holding the clamp and pull the wires out,. The mercruiser alpha one gen ii trim sensors replacement steps.
Replacing Your Mercruiser Trim Limit And Trim Sender Switches from www.sterndrives.com
Your trim gauge does not work. Install trim position sender as follows:. With the drive on you need a long 1/4 drive extension with a u/j and 7/16 socket, with the drive hard to starboard you can undo the bolt holding the clamp and pull the wires out,.
The Trim Limit Switch Is Mounted To The Port Side Of The Gimbal Ring.
With the drive on you need a long 1/4 drive extension with a u/j and 7/16 socket, with the drive hard to starboard you can undo the bolt holding the clamp and pull the wires out,. The mercruiser alpha one gen ii trim sensors replacement steps. To start the alpha one gen ii trim sensors replacement move the outdrive into the lowest position.
Look On The Back Of The Gauge And See If There Is A Br/W Wire There.
The trim senders are located on either side of the gimbal ring. 805320a03 single station trim sender kit $99.92 if you have dual stations (for example, a gauge below and a gauge on the bridge), you will also need to purchase the dual station. Your trim gauge does not work.
Install Trim Position Sender As Follows:.
Disconnect the trim limit switch and connect the 2 wires with the blue and purple diagram of alpha one gen ii (drive.
